WEEK 12

Presentation Week.

 This week All the student need to present their project.

On 3.00 p.m wednesday (week 12), all FYP1 student have to present their proposal of proposed project. Each student are access by two assessor randomly. I has been assess by Sir MUHYI YAAKOB and AZMAN B. ABDUL AZIZ @ YUSOF from electronic section. Alhamdulillah everything was fine and the presentation run smoothly. 

LECTURER :MUHYI YAAKOB

M.Sc in Mechatronics Eng (UniMAP, 2011)
B.Eng (hons) in Mechatronics Eng (UniMAP, 2008)

Specialization:Electronics - Embedded Systems

Sub-specialization:Embedded Microprocessor,Microcontrollers & Interfacing,Digital Signal Processing,Fuzzy Logic Control

muhyi@unikl.edu.my 03 -6184 1000 ext  146

LECTURER: AZMAN B. ABDUL AZIZ @ YUSOF

B.Eng (Electrical & Electronics), Univ. of Hertfordshire, UK (1998)

azmanaziz@unikl.edu.my

03 -6184 1000 ext 236

WEEK 10

Preparation for the presentation.

not much i do during this week, i just make the slide show to convenient all lectures so that this project can be successful for the next semester.

WEEK 9

finding the suitable current transducer.

to measured current of the motor i used this type of transducer name LTS25.

the operation principle is the wire is need to be put inside the hole of the transducer and its will measured the current trough the wire and give an output value in voltage and can be read bu MCU through the analog to digital converter. and this transducer is only need 5 volt to active the transducer.

 the datasheet can be get at http://www.alldatasheet.com/datasheet-pdf/pdf/172078/LEM/LTS25-NP.html