WEEK 12

Presentation Week.

 This week All the student need to present their project.

On 3.00 p.m wednesday (week 12), all FYP1 student have to present their proposal of proposed project. Each student are access by two assessor randomly. I has been assess by Sir MUHYI YAAKOB and AZMAN B. ABDUL AZIZ @ YUSOF from electronic section. Alhamdulillah everything was fine and the presentation run smoothly. 

LECTURER :MUHYI YAAKOB

M.Sc in Mechatronics Eng (UniMAP, 2011)
B.Eng (hons) in Mechatronics Eng (UniMAP, 2008)

Specialization:Electronics - Embedded Systems

Sub-specialization:Embedded Microprocessor,Microcontrollers & Interfacing,Digital Signal Processing,Fuzzy Logic Control

muhyi@unikl.edu.my 03 -6184 1000 ext  146

LECTURER: AZMAN B. ABDUL AZIZ @ YUSOF

B.Eng (Electrical & Electronics), Univ. of Hertfordshire, UK (1998)

azmanaziz@unikl.edu.my

03 -6184 1000 ext 236

WEEK 10

Preparation for the presentation.

not much i do during this week, i just make the slide show to convenient all lectures so that this project can be successful for the next semester.

WEEK 9

finding the suitable current transducer.

to measured current of the motor i used this type of transducer name LTS25.

the operation principle is the wire is need to be put inside the hole of the transducer and its will measured the current trough the wire and give an output value in voltage and can be read bu MCU through the analog to digital converter. and this transducer is only need 5 volt to active the transducer.

 the datasheet can be get at http://www.alldatasheet.com/datasheet-pdf/pdf/172078/LEM/LTS25-NP.html

WEEK 8

this week i go through the anticipated budget for my project. the forecast budget is calculated using Microsoft excel

WEEK 7

study about the wiring diagram of switching in my own car.

the power windows in not operating when the switch is in off and ACC mode. through this diagram the power windows current transducer will be put at the blue wire to measured the current through the motor. the above diagram is the wiring diagram for Proton Wira and the most common wiring diagram for almost car used today.



above diagram is show how the mechanical part inside the switch and the connection of wire.

WEEK 6

this week i need do Feasibility study. First of all what is Feasibility study

Feasibility study

1. What the device is to do?
2. Is the project feasible?
3. Ensure the project can, in fact be accomplished

the first step we need to know what is this device to do. through this i have made a block diagram for the program. its is easy to use Microsoft visio to sketch block diagram.

the operation is when the switch of the power windows is press up the current sensor will detect the current and if its is above 4A the windows is commanded to go down a bit while if is is detect below then 4 A the windows will continued to go up. for the switch down there is direct order to go down the windows. 

WEEK 5

in this week not much i need to do just to conform my project is register in the Unikl BMI systems. and the web is http://fyp.bmi.unikl.edu.my/

this project is successfully registered to the system.